Welcome to the SeeMeCNC Community

Has any one out there got a good, reliable set of parameters for the Rostok Max for these voronoi structures?
All I get is blobs and strings, In ABS.

What's the secret to getting good results on the hollow pyramid? I've calibrated my rostock accurately,I think. I'm getting a very 'knobby' finish, especially in the interior of the legs. I have set all the parameters in the slic3r file to those downloaded from Seemecnc. Any help will be appreciated ...

Thanks.This will get me going.

What are the preferred temps for the extruder and the bed for abs?
I have a Rostok Max and have been unable to get the bed above 85C.
Help and advice anyone?

It does connect to the printer.
The version number is v0.95f
The screen says:
extruder 0 : temp sensor defect
printer set to dry run mode until restart!
I live in NW Ark.
Thanks

The rambo card shows up on the ports menu and is assigned to com4.
I have followed the manual faithfully.
I ran a part( motion only) this morning.
Now I can't even jog the machine or home it with g28.
M119 doesn't work either.
I don't remember seeing the 'SD init fail' message before.

The Rambo card does not show in the device manager.
I have run the machine without the hot end or the hot bed to check everything out.
I now get a SD init fail message when I open repetier.

I'm merely trying to do the setup in the manual before my first print.

when trying to upload the changes to the arduino,I get the following message:
undefined reference to 'loop'
I'm just getting started so I need help ASAP
Thanks

Any Rostok Max users in or near NW Arkansas?