Welcome to the SeeMeCNC Community

Thanks for the input, Shizuma. What was the make and model of your new PSU? I have been experimenting with PLA the last couple days and have gotten much more consistent results than ABS. Except for higher heat applications this is my material of choice for now. With the stock glass plate at 60C and ...

I've attached a shot of my second ABS print at 72%... I re-leveled my bed after applying the PEI (which I failed to do before the first print), and for now my work around for the bed heating issue is to print 60mm off center where my surface temp is reading about 82C. The bed thermister is still ...

You're sure that the thermistors aren't crossed? Pretty sure. The extruder temp control works great so I assume I've got the thermistors wired correctly. I checked the temp at the center of the bed with a thermocouple and it was within a couple degrees of the temp displayed on the LCD. The temp on ...

Hi, I just finished my Rostock MX V2 build last night and today I went thru the calibration. Everything with the build & calibration went very smoothly up until I got to the temperature tuning. The extruder temp kept over shooting the target and failing the PID Autotune. So, I mounted the PEEK fan ...

Hi guys, I'm a newb here. Just ordered my Rostock Max v2 this week. I used to work in a trophy shop and used a vinyl cutter so I thought I would contribute my knowledge.... The cutter we used was very similar to the one Brian posted. The blade has such a small diameter that the back lash from the ...