Welcome to the SeeMeCNC Community

Thanks for the link Mike
ill give it a blurt

Cheers

Trevor

Thanks for the link Mike
Will give it a blurt

cheers

Trevor

Gday Guys, The printer was working fine(ish) but the model came unglued from the base so I turned the printer off , removed the offending model and tried to restart the printer but all I got was the screen previously shown. JJ at SEEMECNC recommends re flashing the firmware and to look at the manual ...

How do you reinstall firmware without booting up??

cheers

Trevor

Gday guys,
I have a problem at boot up IT JUST DOESNT.
I just get the screen as per the photo attached.
Whats the problem an how can I fix it?

cheers

Trevor

Eyup Guys,
The spool is ABS natural.
Tried to post a video but got message MOV files not accepted ?
Will try the calibrations once again.

cheers

Ebygum

Eyup Guys,
Thanks for your comments keep em coming Ill try anything.
I am trying to print ABS.
The filament is the roll I got with the Orion.
I have printed 2 items other than the sample files.
Now everything seems to have gone amiss.

cheers

Ebygum

Gday guys, To cut a long story short carnt get it to stick. Iv tried 1 . Glue stick 2 . ABS juice. 3 . Hair spray 4 . Glue stick and ABS juice I just get a mass at the hot end. I am using MatterControl. Hot end temp 215 - 225 Bed temp 50 - 90 I have levelled the bed , re-calibrated the Z axis ...

Mate,
I have just had a computer meltdown and lost all my data including email addresses.
Please get in touch again with your email address

Cheers

Trevor

Geneb, Where are you in Perth? I am just having problems homing correctly and then printing on the glass and not 50mm away. The following are the steps I take and the results I get. 1.While machine is off I manually push the arms to the top. 2. Turn on Repetier and check Z Max Length in config file ...

Gday guys, Just wondering if there are any Orion Delta users in Perth Western Australia. I recently purchased a Delta but since I connected it to Repetier I am having issues. I have only managed to print two sample files from the SD card VERY FRUSTRATING. If anybody is willing to assist me my ...

Gday,
My Delta seems to have lost its way.
I need to reset the homing.
At present when I try to home the hot end goes straight to the glass.
HELP REQUIRED PLEASE.

cheers

Ebygum

Wossie, I am also a newbie from Perth . I just received my Orion delta from SEEMECNC and it appears to be fine. My other CNC machines are routers which I use for timber products . The 3d printer I am hoping will add another string to the bow the mind boggles. Once I get into it the problem of where ...