Welcome to the SeeMeCNC Community

after some printing at around 240-245 the peek fan just meltdown ... that maybe what your getting right now if everything is good

I would like to know what i need to upgrade to a thermocouple and what i will need to change in the configuration ,

parts i need to buy ,

im already looking to make the upgrade have order a thermocouple but look like i need more than just that

the mod can lock this thread if they want i solved my problem , bought the 850 watt power supply i put in the link in my first post , now the bed heat and power is soo flat same for the hot end the 450 watt supplied with the kit might not be enough to run everything on the long term [img]http://i39 ...

im happy with my 15min , the stock one was taking ways longer than that , now at least i can run all the fan without fearing that i get a power drop and temps drop

finally bought the 850 watt on the link i put in my firstt post , it took 16 minute to reach 100 Celcius faster than with the stock power supply , only problem my new power supply is a little bit longer and dont fit in the oppening , had to put it beside the printer , the things is very quiet now i ...

the stock supply that come with mine is rated at max 22 amps , was not enough for the long print , it wasnt able to keep with the demand , will choice a 2x 12v

finished to install my e3d v6 hotend this afternnoon and while trying to recalibrate the thing , as soon i put the bed on the printer shut off by himself , it done that a couple of time and them nothing anymore look like i have a dead power supply , i found sometime that the 450watt supplied with ...

can be lock and deleted i found the trouble i didnt plug the thermistor cable in the right place ...

3 week ago my rostock max hotend just meltdown so i ordered a new hotend took the e3d v6 but now nothing work , i changed the number in the firmware , like i found but nothing even with a original thermistor nothing work with the stock config , al the axe move via repetier host , but impossible to ...

my problem dont seem to be the brightness i tried to change it but nothing

[img]http://www.servimg.com/u/f57/11/37/22/78/img_2013.jpg[/img]

what my lcd look like

same trouble for me , checked everything and rechecked and nothing only a blue screen who bip if you push the buttom ,

like the title say how far do you go for the calibration of the hot end for the temps ? i must have do the test like maybe 6-7 time always with the new number obtained at the end the hot end during the test was varying only of +/- 1.5 degree obtained from the last temps show on the test

HI, i bought a rostock max v2 , the assembly was going good , now i have a problem the lcd screen still have power and bip when you turn on the printer or pres the button but i have only 4 line of block and nothing else , it show noting i checked the adapter and look good switched the large wire and ...