Welcome to the SeeMeCNC Community

Thank you very much for your help. It looks like everything is working perfectly! So happy now

Thank you for the answers and help. I am though a complete beginner in 3d printing. So I do not know how to fix it Any advice of what I should do and how?

Once again thank you!

That is what it shows.

My firmware EEPROM settings show that Z max length is: -93.193. Could that be the reason why it is not homing properly? If it is, how to fix it?

Ehm, how to invert the stepper directions?

well it was printing fine after I set the printer following the instructions in the manual when it arrived. then for a while I didn't use the printer, so I decided to calibrate Z height before using it again. While I was doing it I realised that I do not really remember if the way I am doing it is ...

Hi, hope you can help me. When I home towers in the printer settings my extruder instead of going up goes all the way down until hitting the heat bed. then I have to switch the power to stop it from breaking. It was working fine before. Any advice how to fix it? Thanks.