Search found 3 matches
- Wed Apr 30, 2014 10:52 am
- Forum: General Tips 'N Tricks
- Topic: Dual extrusion how-to
- Replies: 58
- Views: 48166
Re: Dual extrusion how-to
So I havent been able to figure this out still... Seems my second extruder is tied to the first one and does not run independently. As you can see in the picture, the second extruder should be set to 0* but its not. It increases in temperature when the first one does. Can anyone point me where in ...
- Wed Apr 23, 2014 10:44 am
- Forum: General Tips 'N Tricks
- Topic: Dual extrusion how-to
- Replies: 58
- Views: 48166
Re: Dual extrusion how-to
I have modified the firmware per the original post of this thread. But did i miss somthing that would cause this? what exactly would i be looking for?
- Wed Apr 23, 2014 10:25 am
- Forum: General Tips 'N Tricks
- Topic: Dual extrusion how-to
- Replies: 58
- Views: 48166
Re: Dual extrusion how-to
Hi all. This thread was incredibly helpful getting my dual extruder setup and thank you to everyone for the insight. I'm curious why both extruders heat up even if it is a single extruder print? Is there a setting in the firmware or EEPROM that I'm missing? Seems like whenever i turn on one, the ...