Welcome to the SeeMeCNC Community

$800+ shipping, OBO Location: Hillsborough, NH, USA Needs the small side extruder fan, need to install the see-thru plasic side pieces at the base. works perfect. Getting rid of it so I can buy a CNC Router for wood working. Comes with whatever amount of Red filament is left on the roll as well. My ...

Oh, Thank you

$800+ shipping, Reasonable Offers will be considered. Location: Hillsborough, NH, USA Needs the small side extruder fan, need to install the see-thru plasic side pieces at the base. works perfect. Getting rid of it so I can buy a CNC Router for wood working. Comes with whatever amount of Red ...

A 1968 camaro

I was originally concerned with this when I started printing so I looked up the material safety data sheets MSDA for short, I'm sure you've heard of them. Although abs can be mildly harmful in a non- ventilated area it wasn't overly concerning. PLA on the other hand is almost completely safe. I ...

No it worked fine before, I fixed it but I had to clear and reset up the EEPROM. That's the only way I found I could solve the problem

I moved it a few inches down from the end stops and I hit the set new Z=0.00 key, I hit the home button and it sends all the towers down again. I believe your right as all of these problems started when i originally hit the set Z=0.00 key. So i'm stuck with the same results atm, what should i try ...

i was trying to set a new z height. now i cant get the towers to go up. if they go down they slam into the bed.

Has anyone gone through this calibration guide that already knows these questions? or could answer them for me? thank you Know your stepper motors' full steps per revolution value. 1.8° = 200 steps Know your stepper drivers' microsteps setting. Most Pololus are set to 16x. GEN3 driver 2.3 is fixed ...

red ABS, yeah since then ive changed my settings idk what the original were. I think i need to reset the advanced settings because i set them all to zero

If someone has there rostock max v2 all set up and working great, id like to copy your slicer settings because im having a hell of a time dialing mine in.

What i found was that i was getting the full 12volts from the power supply into the board but everywhere i checked on the board i was getting .6volts So i thought to myself what would put the board in a low voltage state.. I checked all the wires and found that i had reversed the white and black ...

Silly question, but how do i contact support? they dont seem to have an email available.

I got the rostock max v2 together and turned it on for the first time. The rambo fan kicks on so i know its got power but im not getting any signal to the LCD screen. What supplies power to the LCD screen? Also the contrast dial in the back fell off... Here is a video of my problem. https://www ...