Welcome to the SeeMeCNC Community

I've had the same problem happen to me recently and more than a few times. I haven't been able to pin it down exactly, but I have a bad feeling a previous version of Octoprint running on my RPi caused this memory reset. I'm not sure if it's happened since I updated Octoprint. The one time I remember ...

What are you using for the 24V supply? I have 2 ATX PSUs running in series. I'm currently using a 500 or 600W to run everything else, then I'm feeding its +5V to the ground of a second supply. So, theoretically my input voltage is 17V, but I'm only seeing 15.1V across the bed. I've tried running the ...

What PSU are you using for your 24V? Like several others, I'm also considering doing the same thing. My heat bed will never get above 103C and takes a decent chunk of time to get to 90C. I originally got one of the Rev 2 beds with my kit which turned out to be some what defective (it would get to ...

If you're having trouble with your heat bed, definitely get sold of their support. Like a few other people, I contacted them and I'm waiting on the replacement. I was told the week before Memorial Day that they should be getting the new ones in. So, yup, I'm still waiting. On a slightly related ...

Out of curiosity has anyone ran a meter across their heat bed? I'm having the same heating issue with the Rev 3, so I thought I could compare my results. Heat bed running, voltage across terminals: 11.2V Current into heat bed: ~9A (which seems a bit high running on 18ga) Resistance: 1.2 Ohm By Ohm's ...