Welcome to the SeeMeCNC Community

After removing the hot end and de-taping the wiring, I found that one lead was disconnected from the thermistor. The thermistor that came with the kit broke after several attempts at re-soldering. The thermistor that I have now, which is a replacement, reads 200K. How much of a problem will this be ...

Before I take the thermistor out of the hot end and after I un-tape and check the connections, is there a way to test to determine if the legs are touching inside the hot end hole inside the Permatex?

you are correct, the value of the hot end was -20. And after scrolling up the text in the Repetier window I did see that it was reporting that the hot end was defective. Using a magnifying glass and strong light I could see that the PTFE shield is not seated at the thermistor head and that a small ...

I am just completing my build of the RMv2 and am at the stage of uploading firmware. The LCD is alive however the NOZ and BED temps are both reading def. Everything else displays similar to the description shown in the manual. The example in the build manual shows these values to be (presumably ...