Welcome to the SeeMeCNC Community

Gday you lot, thought I might add this to Tips n Tricks. Don't mess with the power supply when you are printing. Two hours into a print and I unplugged my soldering iron from the 4way powerboard that my printer was connected to. After a slight pause in the printer it continued to print... about 2mm ...

I just run standard double insulated automotive two core wire thats soldered to the end of one of the resistors, then the second resistor is crimped to the first.

Guys just thought I would post how significant an improvement that a heated print bed and Kapton tape make to almost completely eliminate warping. I run my heated bed at about 90 degrees under a sheet of glass, which is then taped up with Kapton tape. Printing with the heated glass alone, the prints ...

Im in Australia and get my filament from bilbycnc.com.au I have bought a couple of packs of the mixed 1kg 1.75mm filament. Cost about $65AUD including postage, not too bad. Its good as the colours do last a while and I have a selection. If I run out of one colour, I will just order another mixed bag ...

Just finished a Youtube vid of my machine working, plus a couple of mods I did.
Hope you like.

[youtube]http://www.youtube.com/watch?v=K47d7575WCQ[/youtube]