Welcome to the SeeMeCNC Community

Straight from the man himself. I thought there would be a simple code for it, but couldn't for the life of me find it, but then again I didn't know what to search for. Thanks David, much appreciated.

Good Catch, I think the values for max speed and max instant speed changes must have been the defaults for the configurator, because I went back and looked at the config.g files I referenced and they did not have the values I have. Obviously I don't think that's causing my current problem as it's ...

Thanks for the Reply Deltacon. I don't think increasing the homed height will help as when I started, the "zero" point (where the nozzle touched the bed) was actually at about 3mm (give or take) . It only varied about .015mm between probe points. Increasing the homed height will only make that 3mm ...

Please ignore the M666 X0 Y0 Z0 in my config.g, I was overriding that from the web console.

Hello all. I had to do an unexpected upgrade to a duet wifi after my rambo kicked the bucket. I had to perform this upgrade before I got a chance to upgrade to FSR's so I need to get the machine calibrated manually without them. I'm using David Crocker's instructions found here: https ...

guanu wrote:damn.. 97% through a 33 hr print.... and we reach the end of the spool.... oh well...

image.jpg

Guanu

That sucks, sorry to hear it failed, it was so close. If you don't mind me asking, did you design that or download that design. I'd like to try it myself.