Welcome to the SeeMeCNC Community

Thank you for the reply, seriously.....that's what I thought when I saw the Screen flicker, I knew better. UGH I submitted a few tickets to support but that didn't come up in the email responses. The tickets were then closed so, a bit frustrated for wasting over a week.

So much for using this forum.....

Well it was working just fine and now I can't re-establish connectivity with Matter Control 1.3.

Hi everyone, I've had my Orion Delta for a while and just now getting back to it because work just seems to get in the way of my Hobbies. I love to Build RC Airplanes and hope to get at least some pilots started as well as some scale parts. That said; I just got a set back after upgrading my ...

After installing new carriages on my Orion Delta I went to recalibrate the steppers however; after homing, then move to Z Position, click and turn the dial CC, they hardly move down.... then the LCD resets back to the home start up screen. :?: I must have inadvertently messed up the Z Height by ...

Ok, after further review, it does decrease at the edge of the heated bed between the towers. And slightly increase at the towers. So, the print area is slightly smaller with 269 mm arms (my oversight). Benefits of the IM new carriage include better rigidity through tighter ball bearings and ...