Welcome to the SeeMeCNC Community

Not really true. The standard settings for the Rostock V2 are quite a bit off. After many back and forth discussions with them I have dialed in my PLA settings fairly decently. Let me know if you purchase it and I can send you my setting file.

I got all the way through calibration and was on page 229-230 of the manual. At this point I began to feed the ABS into my machine and prepare for priming. Thern out of nowhere, my machines LCD turned off? The power supply is still on, because I can hear the fan running behind the rambo board. Any ...

Okay. So I figured out what was wrong. My X and Y motors were reversed! I feel like such a NOOB. haha. Thanks everyone for the quick advice!

Did you watch my above video? again here it is below. Please watch it for a better understanding of what is going on. Thanks for everyone's help on this.

https://www.youtube.com/watch?v=5u-7q-7SUNA

So its easier to explain, I just took a quick video... See the link!

https://www.youtube.com/watch?v=5u-7q-7SUNA

The movement does seem to match the others. All of them move up at the same time. One always starts spazzing out though. And its not always the same one. It seems dependent on which tower hits first. The last or third tower never even makes it all the way up. Thoughts?

I sure did. I checked each tower with M119 command and by hand triggering the switches. Each came back working fine.

Any other suggestions?

Okay, so I finally got this thing built. Very excited about using it. I got to page 208 of the manual. All the cheapskates go to the top as they should. But, when they get there whichever one hits first begins to bounce back and forth violently. It makes a lot of noise as well. It looks like 2 of ...