Search found 2 matches
- Fri Oct 11, 2013 5:42 pm
- Forum: H-1.1 3D Printers
- Topic: new firmware but the extruder no longer goes
- Replies: 3
- Views: 8705
Re: new firmware but the extruder no longer goes
No, is Ramps 1.4 Board, but I look like I'm the flower arrangement extruder motor to the right place. I played the test file for RAMPs 1.4 on the board and everything worked. In the Config file I have the board set to 33rd. The extruder was not the hot test. So I have a new extruder fitted with new ...
- Thu Oct 10, 2013 7:59 pm
- Forum: H-1.1 3D Printers
- Topic: new firmware but the extruder no longer goes
- Replies: 3
- Views: 8705
new firmware but the extruder no longer goes
Hello, after i installed the Headbed no longer does my Extruder. Which firmware do you use and how the config files is set with you. Sorry for my bad english. thanks for the help. Marco