Welcome to the SeeMeCNC Community

To come back to this (for my future reference) -- the note above says "a 4mm tube" for 3mm filament, and a nested pair of "3mm inside 4mm" tubes for 1.75mm filament. I assume those are both inside diameters (ID)? And is the inner one of the pair really 3mm, or is it 2mm ID? I ask because SeeMeCNC ...

Thanks, Mike & Eric -- I hadn't correlated that comment in the kit description with what I received -- and wasn't courageous enough to try taking the hotend apart to see where it might go! Since I'm starting with 1.75mm filament, I'll ignore it for now.
Loren

The H-1.1 Kit that I recieved had the extruder hotend already assembled (yeah!) -- but in the bag with it was a clear (more or less) tube. What am I supposed to do with that tube? Is it for insulating the wires (specifically, the termistor wires, I assume)? Or is it part of the guide path for the ...

@Jasco --
I would appreciate that ... I am somewhat out of my league in all this and need every bit of "this worked for me" that I can get!
Thanks.
Loren

Hey, Jasco -- that's lookign really good, and way beyond where I am! (My H1.1 is still in assembly...) If I read the above notes correctly, you're running Rep-Host with Slic3r. Are you also running Rep-Firmware? If so, is there any chance you'd post your config file? That's the configuration I'm ...

Thank you! Those were quite helpful ... much more so than I would have expected!

-- Loren
{H1.1 owner ... as soon as I assemble it!}