Search found 4 matches
- Wed Aug 26, 2015 12:49 pm
- Forum: Troubleshooting
- Topic: Horrific calibration on my end stops.
- Replies: 1
- Views: 1798
Horrific calibration on my end stops.
So after not printing for the longest time after my move I decided to recalibrate my printer and start printing again. BUT I seem to have hit a brick wall. After getting the Z-height done and going to calibrate my XYZ axis, I found something odd. My X and Y sit about a quarter of an inch above the ...
- Mon Oct 13, 2014 8:46 pm
- Forum: Troubleshooting
- Topic: What does my cube tell you?
- Replies: 2
- Views: 2562
Re: What does my cube tell you?
Sorry forgot to mention, it's ABS. These were printed with the extruder at 235C and the hotbed at 80C.
- Mon Oct 13, 2014 4:20 pm
- Forum: Troubleshooting
- Topic: What does my cube tell you?
- Replies: 2
- Views: 2562
What does my cube tell you?
I printed two test cubes, the one at the bottom went nuts and got caught up on something and failed to finish. The one on the top, came out alright except for the back two sides (back in relation to the front of the printer). Is there any reason for something like this? I've gone through all the ...
- Wed Sep 17, 2014 4:02 pm
- Forum: Troubleshooting
- Topic: Nozzle and bed thermistors "defective"?
- Replies: 5
- Views: 5953
Nozzle and bed thermistors "defective"?
I had an issue the other day where my F3 fuse popped while I was doing my PEEK fan print. Now that I replaced that fuse my thermistors (displayed on the LCD) are saying 'def'. When I first start up the printer it says the nozzle is around 20 degrees and the bed is around -22 degrees then switches ...