Welcome to the SeeMeCNC Community

Can the 450W power supply that comes with the H1.1 kit be used for the printer and heated bed? I know the heated bed pulls a lot of current and wanted to make sure it won't interfere with the operation of the printer.

Is there a Mach3 profile for the 4 Axis driver board that I can download?

[img]http://forum.seemecnc.com/download/file ... &mode=view[/img]

What type of filament material was used for this?

The Z axis bushing sleeves don't seem to go far enough into the black plastic pieces that hold them so that when they are screwed against the clear piece they fit snug. There is a small gap. Any suggestions?

I watch the video at reduced speed. I think I will take your advice on reaming the top part.

What about the screws used at 5:16 in the http://vimeo.com/47461857 video. I am using the #6, 1 inch machine screws but they seem difficult to get in. They seem to go in fairly easy in the video. I'm dealing with an injured hand, maybe that's why it seems that way.

I think I'm going to try my best with the video and H1 assembly manual. My wife is getting on my case about spending the money and having nothing to show for it.

I assume the H1.1 could be used for milling also. If so what other hardware and software could be used for this?

Is there a estimate of when the official assembly manual for the H1.1 will be ready? Are we talking about a week, a month? With my lack of experience with this sort of thing I need more than what's available so far.

I looked at the wrong place for the 1:28, that was the entire length. It is at 42 seconds. From the WMV they don't appear to be tapping screws. I can't tell from the http://vimeo.com/47461857 video.

I also referred to the H1 assembly manual but it appears this part has been redesigned for the H1.1.

I am trying to assemble the table subassembly using 71660 SeeMeCNC H1_1 Table SubAssembly.wmv and the posted assembly video 112312229.mp4. What I can't tell for sure is the type screw used to hold down the nut at 1:28 in the vmv video (the vertical screw with the washer). It appears in the video to ...

I only see 3 assembly steps for the H1.1. Would the H1 assembly manual be valid for the rest?

I have inserted some annotations to step 1 to make sure I got it correct. Could someone let me know If I got anything wrong. I was wondering if the super glue only goes on the #6 x 1/2" screws or do the 1" screws get some also.