Welcome to the SeeMeCNC Community

Hello All,

My 25mm fan gone faulty and could not source the same in India, But im finding easily 30X10 mm cooling fan, Did anyone has a shroud design to suit the 30mm fan .

Any help will be much appreciated.

Pingnagan P

Thanks a lot.

Hello Experts Here, I did my bigger print today after calibration, Im happy to see, it came well, while I want some your expert suggestions for any more improvements. Also, Im worried about the breaks in between. Its Printed on ABS Bed :90 degree Hotend: 228 degree Adhesive: Glue Stick Slicing with ...

HI,

I use the paper masking tape, while yet to try the glue stick today, and the Z height is fixed at seeing it flat at top. If possible, I will try to send the pics of the layer.

Pingnagan P

Hello Experts. I have downloaded the Slicr profile from Downloads, and following the settings, while my ABS adhesion is really poor, I can print approx 3 to 5 minutes and the Prints would come off. Im printing with Heat Bed 90 and 228 Extrusion temp. I did gone through some of the forums, Do you ...

May be things to check.

1) The tension on all arms
2) Calibrating for concave or convexity
3) Z Centre height.
4) The eccentric adjustment for the equal tension on movements.

Yes it might take iterations

Here is the pics for reference.

Hi,

Do you have some advice to calibrate the extruder, Since Im getting the top layers while finishing is bad, All your prints look really good, rock on.

Thanks for wonderful acceptance and support, Delta is exciting me than anything else. Its awesome right from Assembling, Calibrating and Printing now, While Im seeing some small rivers, Hope I will cross it with the Team Support Soon.

Thanks again Pals
Regards,

Pingnagan P

Team and Experts, I could successfully print on the Rostock V2, while have some calibration issues, Hope people who have seen it can crack it as soon as you can see these pics. According to me it looks, One Arm, mainly the Z arm is bit lower when compared to the other arms, while seeing this print ...

I could fix the issue with SeeMeCNC support and only seen the reply here now, thanks for the community support. Yes, Flipping the Connectors on the Rambo Side fixed, the catch is to ensure the Notch in the top or the upward direction, Propably in the manual, its not visible clearly, Still the manual ...

Hello Team, I could successfully assemble the Printer, while my LCD controller is not displaying any menus, It would just glow Blue and nothing much. I tried re uploading the FW few times, sometimes the whole screen would blink and nothing much . Can I have some suggestions or advice from the ...

Hello Team,

Im Pingnagan from India, I keep a tab on the 3D printers, while I have made few Cartesian Printers on my Design and pretty excited for Delta Ones.

Need your Support.

Pingnagan P