Welcome to the SeeMeCNC Community

mhackney, I did what you said and then let it go through the calibration crashing into the table again and again for tower X. Then I thought I would try raising the Z-axis calibration by about 5mm. It took a few iterations but FINALLY it calibrated again. Of course I did this all on a cold table so ...

Hi, I upgraded to the HE280 several months ago and performed the bed leveling calibration back then without a problem. Recently I went to use it again and the EEPROM was reset. (This has happened about 5 or 6 times in the last 18 months, not sure why.) Unfortunately I forgot to save the EEPROM ...

I have wanting to get into the 3D printing hobby for a while now, but wasn't sure which one to get. I almost spent $3000 on one of the MakerBot models, but decided to spend less money now in case the technology got cheaper and better in a year or two. I'm an Electrical Engineer but always loved ...