Welcome to the SeeMeCNC Community

@demiurgo Thanks a lot for the instructions, and thanks to everyone who posted. Having this kind of community is amazing at my skill level. Thankfully I figured it out on my own by modifying (i believe ) the pins.h file to re-configure where which port it was outputted to. I popped two of the three ...

Just an update on my situation here: I believe it must be a software problem that the power is going to the wrong RAMBo output considering it does turn on a red LED, just not the correct one. When I get home I think I'll try sticking the black connector adjacent to where the light is, assuming this ...

There is a red LED that turns on but it is not the one directly in front of the black bed connector, I don't know if this matters. The light that is on is directly in front of is labelled Heat 1 (I dont have hotend wired yet).

Thanks for the reply.

Hey, So I'd say I'm about 85% through my H1-1 build and have hit a snag with the PCB heatbed. I have the thermistor working correctly but the board will not heat. I am using RAMBo with the 12v output (Labeled heat-bed) connected in parallel to both 12v inputs on the Phebe. This does not work ...