Welcome to the SeeMeCNC Community

I am using Repetier Host and no I have no tried running from the SD card. Also something to note is that I had a burned out wire to the heated bed on the control board and had to replace that terminal block at the top of the board. I have completed multiple prints since then but I am not sure if I ...

My printer has no problem connecting and I am able to enable both the bed and nozzle heaters. However, the printer is unresponsive to any movement or extrusion commands. Not sure where to start looking for a fix.

I installed my Layer fan but when tested it, it didn't turn on. I assumed it was my wiring and decided to ditch the connectors I had installed. I forgot that my printer was still on, and went a head and clipped the wires to the layer fan to remove the connector. As soon as I cut the wires with ...