Welcome to the SeeMeCNC Community

I have a Rostock Max v2 and I've tried to print a case for my raspberry pi and have found that even though the design in Tinkercad says the part is 61.30mm wide the actual print comes out to be only about 60mm wide. This results in the case interior being too small to fit the pi into and therefore ...

Thanks for the feedback! I'll have to check the print speed since it's the default from SeeMeCNC. The default settings also ran the PLA @ 210C. Would running it cooler help or hurt a print like this? Since I have had a bunch of successful prints (+/- 1st layer issues) I think I am leaning towards ...

I've done a few small items in PLA and the fan shrouds in ABS. Thus far, I am very happy with the quality of my Rostock Max v2. This was my first "big print" that ran more than an hour or so and also was a more complex object than the fan shrouds. I downloaded this object http://www.thingiverse.com ...

@RocketMagnet, thanks for the info! This is my first venture into 3D printing so I appreciate the help. To get started, I did download MatterControl, but I definitely want to spend some time finding the right software. At the moment I am going through the Z height calibration steps in the ...

I received a Rostock Max v2 for Christmas and just finished the build yesterday. I'll be doing the calibration today and would like to run at least a test print tonight. So I have two questions: 1) Right now I only have some PLA meant for the Replicator that I picked up at Staples . If I try a few ...