Welcome to the SeeMeCNC Community

Man you did an awesome job with this file. I'm a huge fan of the Aliens franchise and as soon as I saw this I knew I had to print it. Took me about 35 hours with the settings you suggested but I didn't have everything dialed in perfectly so I had to use a dremel to sand out some of the ball joints ...

Sounds like it was a hear issue; however, I have noticed with my Rostock max v2 that if I start a print from the SD card while it plug into my computer that later on if I disconnect or turn off the computer I've had issues. Usually the printer keeps going but for some reason the temps turn off so ...

SUCCESS! So finally got some time to work on the RoMax over the weekend and I finally found the problem. After taking the belts off of all the skates I went to check how tight each skate was to see if the bearing/wheels needed to be tightened or loosened. On the "Z" tower there was a noticeable ...

I removed the "X" tower belt completely and inspected it: no damage, looks brand new still. Remembering how much of a pain it is to disassemble and reassemble the belts I then proceeded to simply retighten all the belts and try a test print. I tried the Make: 2015 3d Printer test file for Z ...

Got home too late to pull it apart, tomorrow I'll check the belt and pulley tension. I'm thinking since it seems to be leaning away from the "x" tower that something has to be wrong there.

Fairly suddenly I've started to have layer problems with my RoMax V2. Here are some of the successful prints from the first week I had the printer where things worked great and I had (minimal) problems. The whitish cube and the orange peg board were printed out really well and had no problems, as ...