Search found 3 matches
- Thu Jan 15, 2015 2:33 pm
- Forum: Troubleshooting
- Topic: First layer of prints not good
- Replies: 6
- Views: 3750
Re: First layer of prints not good
2. Your nozzle is too far above the print head. I was having issues when trying to print a circle the radius of the print bed, now that i think about it my top plate might not be square to the base.... so instead I cheated and left the head a little high in the middle so that when it went to the ...
- Thu Jan 15, 2015 2:29 pm
- Forum: Troubleshooting
- Topic: First layer of prints not good
- Replies: 6
- Views: 3750
Re: First layer of prints not good
does this include the head fan? I bought an e3d head and it has a fan pointed at the body of the nozzle, should i turn this off?dunginhawk wrote: 1. No layer fans.
- Tue Jan 13, 2015 3:00 pm
- Forum: Troubleshooting
- Topic: First layer of prints not good
- Replies: 6
- Views: 3750
First layer of prints not good
The first layers of my prints aren't coming out very well, i have the bed as high as it will go in temp, 120c, and I have tried with goop on the bed or just clean glass, but i get these results.... I might have the first layer set to high?