Welcome to the SeeMeCNC Community

I think the install of the better TL arms highlighted existing issues in my build. I used a washer on one screw, and shaved another spacer down to fix my high and low points. The bed is now as level as it has ever been. We shall see if i can print a circle. A dial gauge was a HUGE help.

i just used a gauge to get it spot on at the four adjustable points and radius, and I already have the first level set to .30. Thanks. I never noticed this issue before i did the arm swap. the fact that there is a single thin area and leads me to suspect this new arm setup has just highlighted an ...

I haven't even gotten into size adjustments yet. I'm trying to keep the print head from gouging the bed.

I am currently reading this thread and nodding constantly. THIS is my issue. is there a TLDR answer? I'm playing with arm length now. http://forum.seemecnc.com/viewtopic.php?f=37&t=4868 this issue began when i swapped arms. technically the only thing i changed was arm length. but how am i going to ...

I just installed my tricklaser arms on my Max V2 tonight and the slop is GONE. After doing another bed height adjustment and subsequent diameter roundness tweak and endstop adjustment, i tried to print the 200mm test circle pattern. It did not go well. The outer circle between the towers (outside of ...

I'm in Middletown and just booted mine up last night. My only nozzle hit the glass during the Z cal and collapsed. now i can't calibrate and it is KILLING ME. You would happen to have another nozzle, would you? Will trade for drone lessons and a frosty beverage of your choice.