Welcome to the SeeMeCNC Community

So the next generation of heater/venter. I use 11inch polycarbonate panels with trapazordial bottoms and tops so the entire printer is enclosed with lots of room for the arms to move around and for me to get at stuff in the chamber to tighten and adjust. It forms a very nice hexagonal enclosure. In ...

I've cut a couple holes in my chamber to run 3 inch duct out and I hook it into a hair dryer (1850 watts and very controllable). I have that plugged into a temperature control thermostat and I can set it to whatever temperature I want up to 100 celsius. I had a problem with the intake being too hot ...

ok ... so I have a theory on this. From what I can tell by reading this thread there is nothing wrong with any of the hardware or electronics. I believe that this is a design issue of delta arm printers. Delta arm printers use some pretty complex math to determine exactly where the positions of the ...