Welcome to the SeeMeCNC Community

@polygonhell - I usually almost exclusively use Hatchbox supplied filament, although I have tried spools from different manufacturers and gotten the same results. When printing I typically can't get far enough into the print to get to the overhangs, if there are any. This "globbing" of material ...

Hi All, I have a Rostock max v2 with Tricklaser arms, E3D v6, stock extruder, trucks, and extruder platform. I use Buildtak sheets on my build plate because I love the finish it gives PLA prints as well as being much easier to remove prints. For calibration I will either use a .051mm feeler gauge ...

Got my hotend taken apart and sure enough the hole in my nozzle has gone from .5mm to 1.5mm. I have never even touched the nozzle, or let it hit the print bed hard... What could have caused this? sounds like it was drilled too far and the tip blew out, email [email protected] with your order ...

Got my hotend taken apart and sure enough the hole in my nozzle has gone from .5mm to 1.5mm. I have never even touched the nozzle, or let it hit the print bed hard... What could have caused this?

I upped my e-steps from the default 92.65 to 129.5 and dropped my z-height back to the level I felt was giving me the best consistency and re-calibrated my end stops which helped a LOT early on in the print, but im still not getting extrusion while my perimeters are being laid down, and further on ...

Hello All, Noob here, just built my Rostock Max V2 this week. Loaded up Mattercontrol with the stock settings file and calibrated the machine according to the instruction manual, but I am having some major problems with my ABS prints. It seems like the extrusion is very uneven, and after watching it ...