Search found 3 matches
- Tue Feb 10, 2015 10:30 am
- Forum: Troubleshooting
- Topic: Ran into snag during build (Rostock Max V2).
- Replies: 5
- Views: 4701
Re: Ran into snag during build (Rostock Max V2).
I know. It's bizarre. That's why I posted the pic. It's kind of hard to tell, but if you zoom in you can see the 8 pin, but the 4 pin... nothing. I'm working right now, so I can't grab it to check the type.
- Tue Feb 10, 2015 8:26 am
- Forum: Troubleshooting
- Topic: Ran into snag during build (Rostock Max V2).
- Replies: 5
- Views: 4701
Re: Ran into snag during build (Rostock Max V2).
Thanks for your reply. You're probably right. I don't really know enough about the power, I'm just familiar with the connectors. I wasn't sure how much runs through the wires on each connector, or if they're all the same. I also don't know if I were to pick one of the SATA lines and used the last ...
- Tue Feb 10, 2015 12:26 am
- Forum: Troubleshooting
- Topic: Ran into snag during build (Rostock Max V2).
- Replies: 5
- Views: 4701
Ran into snag during build (Rostock Max V2).
Alright, first 3D printer. I'm following the instructions the best I can. On pages 34-36 it says to cut the wires to the 8 pin connector for the heater bed. No problem. Then it says to cut the wires to the 4 pin connector to power the RAMBo board. Problem. The power supply doesn't have one. What ...