Welcome to the SeeMeCNC Community

Yes, the fan is running and the blue LED's are on.
I will check for continuity tonight.
Thanks.

I did not.
How can you tell if it is bad?

So I have been using my ROSTOCKMAX v2 with my new HE280 for a number of projects over the past 3 weeks. Probably put in 100 or more hours of printing with no issues at all. All of a sudden, on my next print the hot end will not heat up. When I manually adjust the extruder temp on the LCD panel, I ...

I also have a V2 and I also had the issue of the HE280 crashing done onto the plate and continuing to drive straight to China. After 3 days of searching this forum and trying everything I was reading, I finally just stuck an Ohm meter to every pin in the 8 pin connector and for each pin I stuck the ...

Hey guys, is there any way to use this software now manually instead of with the automation like the first few versions?

I actually just had this exact issue happen to me last night on a 15 hour print. The loom caught on one of the upper arm pin ends and ripped the arm off. Just snapped back on with no damage done. Need to recalibrate tonight and check the length of the bowden tube clearances more closely through its ...

Can someone please clue me in on what setting in Simplify3D sets the height of the bed and then zero's it out at that level.
I have been going through setting after setting and every time I start a test the nozzle tip touches the glass.

I use 235C on the head and 105C on the bed with hair spray.
Great results.
Just ordered a new spool actually.

Tom

Going in and saving the preset did the trick.
Thanks Teoman.

I have a question about editing the custom G-Code in the MatterControl. I am trying to add in the Starting G-Code a line of code to start the fan at 50% M106 S50 I can add and hit the save button with no issue. It seems to have saved it in the Start G-Code section. However, when I try to save the ...