Welcome to the SeeMeCNC Community

I haven't had any issues with the acetyl u-joints, but I did sand and smooth out the molding/cast marks inside the stock arms. As for the resets , not one problem since installing the lastest firmware from the seemecnc GitHub(which I don't think changes anything) and I stopped using mattercontrol ...

I think i have figured out the wierd artifacting isssue with my prints I had 5 frozen U-joints..... I took them and the rods off gave them an Acetone & ethyl Acetate bath, washed them put them back on and used some lithium wheel bearing grease (plastic safe) and now that part seems to be working ...

The slicer doesn't care what machine it's generating code for. The GCode is all cartesian moves in mm, the Firmware does all the work to translate to the delta geometry. The only things those values are used for is to draw the pretty picture of the build area and possibly warn you if the piece ...

You might want to checkout this page for more info on the issue between towers. It's a long read, but worth it. http://forum.seemecnc.com/viewtopic.php?f=37&t=4868 I did that and ran the script that was used to check each of the points and i have my machine dialed in to where only 1 of the points ...

Your resets are a bit different from most others that are using MatterControl. We're seeing resets that are going back to the initial firmware EEPROM defaults which mostly effect the horizontal radius and the overall Z-height. This causes the printing in air issue upon the next print attempt and ...

There really oughtn't be a way to reset the eeprom unless the GCODE is being corrupted while being sent to the machine. Several people seem to be having this problem lately though. When you use repetier host, do you have it set for the binary protocol or the ASCII one? You can turn on logging in ...

Eaglezsoar wrote: Perhaps Casper the friendly ghost?

I don't think i would say "friendly" in this case unless it decides it is done playing and comes up with a way to fix itself

Another thing that I forgot to post that has happened since all of this started happening, is that sometimes (maybe once every 15-25 prints) I will hit the home button in octoprint or Repetier-host and it will try to run the extruder rather than moving the effector back to home for about 10 seconds ...

@KAS I use a couple of different slicers and have tried using just Slic3r and Slic3r through Repetier Host(I use it on linux and windows) I also use Cura through Repetier host and it all seems to have the same effect.... All my prints are through the usb port. I print some with an Odroid running ...

As of late i can get about 3-5 prints out of it then the EEPROM resets to factory default.... After that if i upload "working" EEPROM settings the machine is no longer level. This is without touching anything else....The only upgrade/s that have been done to the stock part of this printer is going ...