Welcome to the SeeMeCNC Community

have you confirmed that your endstops are working properly?

You may know this already but use M119
X_MAX:L Y_MAX:L Z_MAX:L would be all have not been hit
X_MAX:H Y_MAX:H Z_MAX:H would be all endstops are hit

Jake.N

What is the J head's black piece make out of?

I am going to start on the prototype this week

I don't know if this is the right place to ask but for school I need to build some thing and sell it. my school shop has a mill that I was going to use it to make a all steal hotend If you are interested let me know. I am thinking for a price about 15$ plus materials and shipping. my basic plan was ...

Host is not set to dry run and the bed works I am testing the PID now.

I am running M303 S200 to try the PID but log reports nothing because the command is waiting. Am I using the wrong command?

Okay I am not understanding your suggestion. The voltige at the screws in zero.The board is not putting power to the hot end or fans with none of the fuses blown to me it seams like its not in the wires

That was my first thought so I took the voltmeter set to ohms and put it to the body of the hot end and the positive then the negative on the board and had no continuity. However not the wires in between the board and head could be shorted I am going to check that now. thank you Okay just tested it ...

this started just after I printed my first cube. When I try to tern on the fans or hot end in manual control or when printing the fans and hot end don't get power from the board. I have tried up dating repetier and the firmware. I tried replacing the RAMBo. I was running two fans out of one fan port ...

did you hit compile the button next to it first?

it was the fuse. Dose anyone know the specs for a replacement? are they 5 amp or 10 amp?

good to know

I don't have the LCD and I know the fans work it's the Rambo that is not putting out power.
EDIT: now bed and head not heating up but, motors work

I have printed my first cube but, after that I was about to print another when my fans would not spin. in repetier host manual control I powered on the fans and tested it with a voltmeter and there was no voltage to the fans. I tried the pins on the board and the slotted screws on the connector. I ...

for 1.0 users use 44 steeps per minute

I did not realize that. I am talking about the tubes inside the hot end.

I warped, ruined and split my PTFE tubes and wanted to replace both of them. Ware can I get a replacement please.

so, how did you fix it?

okay thank you

Recently i upgraded to an EZ extruder and I wanted to know how to calibrate it?

thank you

I upgraded to an EZ extruder i got the version that came with a motor and it had different colors, red, blue, green and yellow. I tried substituting the yellow for black but the did not work. Is there a new wire configuration for this newer motor?

ware else would be 12v?
EDIT: thank you did not see your EDIT

my power supply only has two yellow wires on the 22pin and the instructions ask for 3

(I am new) This might be the wrong place to post this question but, if some one could point me in the right direction that would be much appreciated . I was putting my Thermistor in the bed and managed to pull one of the leads out

Ware can I get a replacement Thermistor?