Welcome to the SeeMeCNC Community

Ok worked til wee hours but found out what the culprit is. You were correct that its either the stepper (UNLIKELY) or the wireing. I ended up re crimping and running all new wire and ran it directly to the extruder stepper motor and bingo. So must me a short or bare spot in the wire going through ...

3 motors and 3 new crimps and connectors later, wired every way possible (first way was correct but tried em all), motor won't turn. Just clicks. 23 hrs of a semi easy build and it comes to this? I did have this clicking problem before the first print and took the extruder apart and checked ...

OK I'm going to re crimp and put in a new connector again. I'll re post after. Thanks!

Just vibratess does not turn

Rostock max v2 extruder just clicks, changed it out and second motor just clicks. Changed config H settingd to motor current 155,155,155,165,0 still just clicks. Pulled 4 wire plug and re attached. Just clicks. Took off extruder and motor alone just clicks. Help I don't want to type JUST CLICKS any ...