Welcome to the SeeMeCNC Community

Polygonhell wrote:...some Cartesian printers run as high as 9000, which will make...

Not over 9000?!

Take a look at the belts on all the towers so that you don't have any wear or irregularities on them?
Maybe the servo chewed up some teeth when you got stuck?

Thank you, will try this tonight.
The push-fit connectors are a bit "vauge" (ie. I can move the tube a bit, but it wont come loose until I release it the proper way)
Will have a closer look at them aswell and see if they move during printing..

Alright, so I have some small artefacts on my prints. They seem to be most prevalent when the printer starts a new layer or is jumping between separate parts of the print. What could cause this? Moisture? Over-extrusion? IMG_3480.JPG Im printing with SeemeeCNC's Black ABS at 228c and a bed temp of ...

Nice! Noob question:
Since my printer only is about a week old i have no idea how to actually "change the start up GCODE"..
Is there any good posts/guides on GCODE that you could recommend?

Very neat!
Is the Astrosyn dampers necessary in you opinion? Where did you buy the mic-6?