Welcome to the SeeMeCNC Community

This was after appx. 20000m of filament. Most types of filament has been through this printer at one time or another but its usually abs. The effector shown originally had capton tape on the inside (closest to the heater-block) until it came off. The latest Petg version is showing a slight bit of ...

I usually print it about PETG @ 240-245 and abs about 225. it would seem to be. Here is a good read.
https://all3dp.com/petg-filament-3d-printing/

Went to install the replacement E3D socks that I finally ordered. It had approximately 20km of filament run through this effector plate. Most of the time it had a silicone sock.

The v2 is over a year old with a very strange problem to me. Background: Life- 168 days+, 28km of filament, owned 1y2m. Upgrades- e3dv6 a year ago, trucks and arms within a month of them being released (both awesome upgrades). The dilemma is it started printing poorly (delamination between layers ...