Welcome to the SeeMeCNC Community

FYI anyone who comes across this later and also gets the kit, you do not need to use the side plate to bridge the gap, the hole in the bottom is actually good for ventilation on the psu... you can use this template that is linked on the psu kit page to mark the holes to drill. Guanu Does anyone ...

I messed up the settings on my MAX v2 (July 2015 Kit) and decided that I'm just going to start over with the newest software and do a full calibration. The Firmware 20170201 has a nice #define PRINTER 2 line, however, * it's not using the same arm length * the Z height is wrong * it thinks I have ...

Just had this problem happen. Can someone explain why I can't remove the melted terminal and solder the bed wires directly to the board?