Search found 6 matches
- Mon May 20, 2019 6:49 pm
- Forum: Rostock MAX
- Topic: RAMbo reboots during slow prints (<40 mm/s), but works fine in faster prints
- Replies: 2
- Views: 7195
Re: RAMbo reboots during slow prints (<40 mm/s), but works fine in faster prints
I believe I've figured it out! In addition to my main speed being extremely low, my first layer speed was set to 5%, which is apparently too low for either S3D or the RAMbo to handle. So far, after changing it to 50% my prints are surviving with no problems. If anything changes I will report here ...
- Mon May 20, 2019 2:23 pm
- Forum: Rostock MAX
- Topic: RAMbo reboots during slow prints (<40 mm/s), but works fine in faster prints
- Replies: 2
- Views: 7195
RAMbo reboots during slow prints (<40 mm/s), but works fine in faster prints
Hello all! I'm having an issue where my Rostock Max V2 reboots during slow prints. I've reproduced it reliably somewhere around <40 mm/s. basically, the printer finishes the skirt just fine at the slow speed, but when it starts the print, it usually can't finish even one layer, (sometimes even a ...
- Wed Oct 19, 2016 10:32 am
- Forum: Rostock MAX v2
- Topic: Skipping 1/100ths of z steps, possibly others.
- Replies: 7
- Views: 5536
- Tue Oct 18, 2016 8:26 pm
- Forum: Rostock MAX v2
- Topic: Skipping 1/100ths of z steps, possibly others.
- Replies: 7
- Views: 5536
Re: Skipping 1/100ths of z steps, possibly others.
My prints are not great.
But if this is not something to be concerned about, I'll be okay.
If I need help with the rest, I'll articulate a thorough report of the symptoms in another thread.
But if this is not something to be concerned about, I'll be okay.
If I need help with the rest, I'll articulate a thorough report of the symptoms in another thread.
- Tue Oct 18, 2016 8:07 pm
- Forum: Rostock MAX v2
- Topic: Skipping 1/100ths of z steps, possibly others.
- Replies: 7
- Views: 5536
Re: Skipping 1/100ths of z steps, possibly others.
So this is normal behavior and I shouldn't worry about it?
- Tue Oct 18, 2016 12:29 am
- Forum: Rostock MAX v2
- Topic: Skipping 1/100ths of z steps, possibly others.
- Replies: 7
- Views: 5536
Skipping 1/100ths of z steps, possibly others.
I noticed it a long time ago during z-calibration; it counts down, but skips occasional 1/100ths (.01) of steps along the z axis. I.e.: 09, .07, .06, .05, .04, .03, .01, .00, .x9, .x8, .x6, .x5, .x4, .x3, .x1, .x0 etc... Ive been struggling for about a year and a half and still haven't gotten to the ...