Welcome to the SeeMeCNC Community

My first Onyx bed was warped by at least .050 from center to edge. The replacement Onyx was about just a little better than the first. I have zero confidence that seemecnc even QA's the beds before they ship them. Both of the beds I received were so badly warped that just placing them on a flat ...

The shipping/packaging looked fine. They are probably warped from the traces shrinking. Maybe they had a bad batch of boards and I got two from the same lot. They are both visibly warped when you put them on a flat surface.

The bed is warped before and after heating. Loosening the screws and heating the bed did not help with flattening it. Both Onyx boards I have received are heavily domed in the center.

I just put together my first Rostock v2 and encountered major issues calibrating due to a seriously warped Onyx bed. No amount of loosening, heating, and fiddling could flatten my warped bed. The borosilicate plate conformed to my warped bed. Seemecnc sent me a new bed today and it is more potato ...

I know this is probably a newbie question, but is there an easy way to ID a nozzle diameter? I noticed some dots on one. Are they marked in any standardized way?

Hello all, I have been interested in 3d printers for quite a while. My boss surprised me and ordered a Rostock Max V2 with a bunch of upgrades. I was tasked with putting it together and getting it working. It went together pretty well, but my Onyx bed was warped beyond repair and gave me mega cal ...