Search found 4 matches
- Wed Apr 03, 2013 2:42 pm
- Forum: RAMBo
- Topic: Firmware for the new RAMBo
- Replies: 9
- Views: 9774
Re: Firmware for the new RAMBo
Is there anywhere I can find the current firmware for my Rambo Board? I'll admit that I am pretty new at these things, but I went through all the information I could find about the Repetier Firmware at https://github.com/repetier/Repetier-Firmware and I'm totally confused about how to actually ...
- Tue Mar 05, 2013 11:34 am
- Forum: Troubleshooting
- Topic: Instructions on the electronics and hotend.
- Replies: 4
- Views: 4519
Re: Instructions on the electronics and hotend.
Hi Kris,
I dont have an answer for you, but I do have all the same questions you have. Were you able to find a source that explained (in somewhat plain English) how to wire up the electronics? Any advice at this point would be great!
-Jon
I dont have an answer for you, but I do have all the same questions you have. Were you able to find a source that explained (in somewhat plain English) how to wire up the electronics? Any advice at this point would be great!
-Jon
- Mon Mar 04, 2013 3:35 pm
- Forum: The Build Zone
- Topic: DMPalmer's H1.1 build
- Replies: 9
- Views: 11440
Re: DMPalmer's H1.1 build
Dmpalmer, this was an awesome post! Thank you so much for going in to all this detail about your build. Totally invaluable. I was wondering if you could fill me in just a bit on how you wired your RAMBo? I realize I should know better, but I simply have no idea how to read the fancy-pants ...
- Thu Feb 07, 2013 6:15 pm
- Forum: The Build Zone
- Topic: Build question: pulley fit?
- Replies: 1
- Views: 2509
Build question: pulley fit?
Hi, This is my first build (H1.1) and I am right now working on the rear base sub assembly. I am trying to fit the pulley onto the stepper motor as shown here: http://seemecnc.org/download/H1-1/H1_1%20Assembly%20-%20Step%203%20-%20Rear%20Base%20Sub%20Assembly.PDF but I'm not sure how far down to ...