Welcome to the SeeMeCNC Community

I am not sure if im not seeing another post on this. I any case my machine is not running the level correctly I seem to have an issue on my Y axis it does not seem to want to move properly. I though it was a bit loose so I tightened it but that doesn't seem to be the issue. when going through the ...

i do use glue. I going to try readjusting the z height at each tower again and see if that corrects the issue.

I use a raft but i might need a bigger one and thank you for the tip on the towers that is just what i needed to know

its not my z heigth the part im printing now which is the holder for the matter control touch is warping higher and higher off the bed as it prints. im watching it lift off the bed.i am hard pressed to believ its the Z height. doesnt mean im wrong, however

im using matter control for slicing on my machine in the past on another machine slicr and Cura gave horrible results pretty much exactly like you were having since i switched no issues. your print is only as good as the slicer try matter control and see if it rectifies it

So can I bring up and down on the outside corner through software? because Z height in the center is dead on and that side appears to be the same I measured paper till i found on that was .2 mm and it just touched that paper just scraped it.

Hi im having an issue when printing large objects one corner and it is the same corner lifts from the bed. Do i have something not adjusted correctly, i( it is probably that) or is the bed temp to low 60dgrees C and Im printing PLA, i have not printed anything large in Abs yet so i dont know it is ...

cool thank you

Thanks i didnt see that till later. ive been working on it for about 2 months and for got some of what I read ahead of time. that was also my fear of building wrong. but now that im done i love it

Hi all my name is Bob Im in florida putting together My new Vmax and I really enjoy the build process. i have a question though because ive gotten to a point and im seeing a contradiction on the bottem top plate orientation on page 94 i belive it is it shows the Orientation which is the same one ...