Welcome to the SeeMeCNC Community

Hi Vikingfx, I didn't really get the chance to test this as I've just moved on to an E3Dv6, but I did modify the original fan mount for that exact fan. I've ordered two of these fans, and both had a different dimension on the nozzle, so it may be worth double checking your fan before printing this ...

My new bed is warped to. High in the centre by about 1.2mm. I take it the only way over this is a replacement heat bed then. Same here for me, I'll put up a picture when I get home. Like someone said previously in the thread, it could be a bad batch. I've just got to the part of the build where you ...

Dave, you have it correct. Yes, it's confusing and I apologize. The whole point behind the graphic on Page 94 was to make abundantly clear how it was supposed to go. "You'll want to orient the top section base plate as you see above. This will help ensure that you don't accidentally build yours ...

Hi guys, first time posting here. I've been setting up my kit for the last week and so far I'm enjoying doing so. I have got to installing the top plate, but I've run into a bit of an issue. In accordance to the manual on pages 94 and 104 I assembled the top plate and tower supports as shown. Page ...