Search found 5 matches
- Wed Nov 18, 2015 4:05 pm
- Forum: Rostock MAX v2
- Topic: Rostock Max V2 not connecting
- Replies: 3
- Views: 3094
Re: Rostock Max V2 not connecting
Newest Versions of both. MatterControl 1.4. Reperier Host 1.6.0. Windows 8 on one and Windows 7 on another. Happens to both computers. Just got the Rostock a week ago. When I turn it off and on again on the printer it goes back to being Rostock "OK".
- Wed Nov 18, 2015 3:37 pm
- Forum: Rostock MAX v2
- Topic: Rostock Max V2 not connecting
- Replies: 3
- Views: 3094
Rostock Max V2 not connecting
I am at my instillation stage for software. Everything was working fine until I installed MatterControl. I did the M119 and checked the stops. After I put in the new coordinates to move it down a couple CM. It just went blank. My rostock is not connecting to any of the computers. Matter Control ...
- Sat Nov 14, 2015 2:12 am
- Forum: General Tips 'N Tricks
- Topic: Rostock max v2 instruction error.
- Replies: 1
- Views: 1981
Rostock max v2 instruction error.
So apparently the pictures on 96 and 100 are different for the top plate! That blows. Completely messed me all up.
- Sat Nov 14, 2015 2:10 am
- Forum: New Member introduction
- Topic: Greetings from New Mexico
- Replies: 3
- Views: 2887
Re: Greetings from New Mexico
So apparently the pictures on 96 and 100 are different. That blows.
- Wed Nov 04, 2015 12:47 pm
- Forum: New Member introduction
- Topic: Greetings from New Mexico
- Replies: 3
- Views: 2887
Greetings from New Mexico
Hello,
Greeting from Las Cruces, NM. My friend picked up a rostock max V2 after I saw it. I knew I wanted it. Haven't put something this big together yet but I follow directions well. Well thanks for looking.
Greeting from Las Cruces, NM. My friend picked up a rostock max V2 after I saw it. I knew I wanted it. Haven't put something this big together yet but I follow directions well. Well thanks for looking.