Welcome to the SeeMeCNC Community

Roger that!

Thank you,
PM

Hello, Just recently switched to Repetier 0.92.8. While calibrating the system last night I had a decimal error in one of the values I put into the firmware and the endeffector slammed hard into the bed and stalled. The sound of motors growling ensued as I lunged for the power switch. Fast forward ...

New configuration file fixed whatever got corrupted. Blobs all gone. Back to printing little black squares.

Side question: The 20x10mm squares are coming out 19.7mm square x 10.2mm. Is there a dimensional scaling factor in the slicer software or Firmware that I missed?

Thank you,
Patrick

Hello,
It happens every time with the configuration I set up yesterday and tweaked today. Here is the g-code for the same STL run through mattercontrol.
I'm just starting over with a new configuration in repetier. I'm sure it will print fine. I just don't know what I did to create the blob...feature.

Hello, I changed one too many things this weekend and can't figure out what. I've got my new Rostock Max v2 working and calibrated using mattercontrol. I'm in the learning to print better 20mm-boxes phase and was giving repetier a whirl to see what that software package had to offer. As expected the ...