Welcome to the SeeMeCNC Community

I built my Mk2 around Feb 2016, and used the most up to date information at the time to set it up. Since then, I replaced the hotend with an E3D V6, because I had a lot of smoke come out of the stock hotend from the heater block. I remember reading that the stock heater resistor ( or what ever it ...

Thank you for the advice, it has helped quite a bit. After reading through your guides, I lowered my retraction to 2mm, got rid of my coasting settings, and have a small wipe move around 1mm. I also sped up my travel movement for non printing moves, which also seemed to help. I have almost printed ...

I got to 4mm retract distance by repeatedly printing the 3dbenchy, starting with no retraction, and slowly building up from there. I found the lower retract distance left me with a ton of strings and big blobs on the outer layer. Are there ways to minimize those problems while keeping my printer ...

I have been experimenting with that. My last setting were : Retraction : 4mm Extra Restart distance: 0mm Retraction Vertical Lift: 2.6mm Retraction Speed: 25mm/s Coasting distance: 3mm Wipe Distance: 2mm These were the settings that I was using to get some good prints with my older roll of PLA. I ...

I have been fighting my printer for the past couple of months. My filament keeps jamming in the hot end after 30min of printing or so. I have a Rostock Max V2 with a E3DV6, and it was printing great until my computer crashed and took all my slicer settings with it (simplify3D). Since then, I have ...

Hi there, I just finished building my kit that I ordered last week, and have been printing stuff non stop. Other than fine tuning setting, the prints have been coming out great. My problem is with the speaker on the lcd pannel. According to the instructions, it's supposed to make sound when the ...