Welcome to the SeeMeCNC Community

JT- Did you get your printer working? I melted my first hot end before I could even get it to print. I just installed the new 3mm hot end and and turned it on and tried to watch the Velleman board to see if it would kick off and it just stayed on. So I turned it off. I'm starting to think the ...

Last night finally had everthing working. I tried my first print and I noticed that the extruder wasn't getting hot enough. The PLA was very stringy and not sticking well. Opened the manual and notice that I was suppose to change out the resistor R5 on the Velleman board, so I changed the resistor ...

How can I tell if the Gcode is using the A axis for Extruder moves? What am I looking for?

Thanks,
Ressie

How I do that?

Hey Guys, Does anyone have a stock mach3 xml file and a simlple piece of g-code I can try out? I can control the extruder from mach3 it moves when I press the keys on the keyboard but when I send the star.nc code it only moves the xyz motors? I have a stock H-1 and I am using PLA my mach3 is set to ...

I just ordered a couple of new PEEK barrels...I was wondering about the thermistor not working. I had the board set to the lowest setting and the relay did not switch off. Where about on the dial should I set it to? Is there away I can check to make sure it is working ? Also do you guys fill the ...

Hey guys my hot end fell apart! hotend1.jpg I turn on the power supply and I notice that the hot end was getting hot so I manually inserted the PLA in the extruder and the hot end started to extrude then the hot end fell off. Should the hot end get hot before the g-code is sent? Also I tried to ...

I would love a bearing upgrade. Just let me know what to do.

Thanks,

Ressie