Search found 3 matches
- Sun Aug 07, 2016 10:33 pm
- Forum: Rostock MAX v2
- Topic: Heated bed temp shows that it is going up when it is not
- Replies: 1
- Views: 2135
Heated bed temp shows that it is going up when it is not
I have had my Rostock MAX v2 for several months and recently I started having problems with objects not sticking to the bed. I finally noticed that the bed temp read out said that it was at 65c when I had it set for 55c. I felt the bed and it was defiantly below 55. I turned the printer off and back ...
- Sun Jun 26, 2016 8:56 pm
- Forum: Rostock MAX v2
- Topic: Gaps in print between Z and Y
- Replies: 2
- Views: 2602
Re: Gaps in print between Z and Y
I have calibrated it and it doesn't seem to change the first layer, shouldn't calibration take care of a bed level issue? If is tower lean, do I level off of the print surface or the surface under it?
- Sun Jun 26, 2016 2:40 pm
- Forum: Rostock MAX v2
- Topic: Gaps in print between Z and Y
- Replies: 2
- Views: 2602
Gaps in print between Z and Y
I have had my printer for a while and I get gaps between perimeter and the infill between the Z and Y posts. I have zeroed out Z and have the center and all 3 posts are calibrated. I have tried this with both MatterControl and Simplify3D and even though the print is some what different, they are ...