Welcome to the SeeMeCNC Community

Had a second heating resistor go out on me in about a month or so. Had an E3d that i have been wanting to try, so I disassembled the stock hot end (max V2) and installed the E3d using a seemecnc thermistor. When I disassembled the stock hot end to change it, I noticed the fan mount to the cooling ...

Is there a chart that shows the motor current output for the different numbers in the configuration?

Stock MaxV2

I am wanting to use a different extruder motor with lower current, and trying to find a chart for the settings.

Thank You. That is what i needed. The manual i downloaded used mattercontrol instead of repetier. I have been using repetier for 2 days now and so far I think it is better than mattercontrol!

I wanted to try repetier and slic3r with my max v2.
Other than the normal speeds/infill/temps/etc...
Do I need to also setup the starting and ending gcodes under the printer settings/scripts?
What else do i need to setup that isn't obvious?
Is there a faq or manual for this?

I would like to raise the height of the hotend if the print is paused. How can I do this? It currently seems to only go up about 25 or 30mm. I would like double that.

I am installing an E3D v6 hotend with the 100k NTC 3950 thermistor. Where do I change the info in the firmware? Is the Rostock Max V2 firmware already set up for this? Also, If i change the hotend thermistor, does it have to match the bed thermistor?