Welcome to the SeeMeCNC Community

a. Diagonal 290.00, delta radius 143.06, homed height 385.11, bed radius 140.0, X -0.60°, Y -0.25°, Z 0.00° b. Endstop adjustments X0.01 Y0.11 Z-0.11 c. Bed probe heights: 0.154 -0.113 0.101 -0.149 0.100 -0.108 -0.073 -0.013 0.090 0.067 0.015 -0.058 -0.032, mean -0.002, deviation from mean 0.093 d. 1 ...

Awesome, glad to hear that that worked out Jim. I am going to give it a shot too once I have some time. Question before that though, how were you able to go into negative 0 values? I've tried before and I cannot go pass 0? I actually saw you post this on Thingiverse first and then came here to reply ...

Here are my configuration files. My config.g and bed.g files are attached.

shodapublicity - Congrats on solving this. I'v been having a very similar problem, and had pretty much given up on my FSRs and gone back to turning bloody screws, and sliding around MFn paper. You've given me hope. Would you mind sharing the configurations you're using? I'm still using the original ...

I did change my bed.g file to try some different probe points, and I'm still having trouble. The file I tried did 0,0 first, then 8 points on a 250mm circle, and 6 points at 125mm. Same results, so it's not a math anomaly or fluke. This is probably what's going on. I can see my hotend deflecting ...

I watched as the skirt was printing and I noticed that my bed is not level at all. It varies off and on but due to the starting Z offset that I set it offset most places and allowed for printing. More work left to do, but for now I am happy. I am going to order some Hall Effects for my endstops as I ...

Kept at it and then tried printing something to test. Was paying attention to my other printer and this happened... Its not perfect, but it is a lot better than before. Victory!

I noticed that my bed is more sensitive than others and I believe that is why I am running into this. I've tried various mounts, and techniques but yet still nothing.

I tried manually following along the hotend with the FSR but even that did not work...

I have been trying endless to no avail to level my Rostock Max v2. I can get prints that stay within the center to print really well but anything on the edges and it does not. Spend my whole entire day yesterday trying out various things to get my FSR sensors to trigger more evenly across all points ...

Yup, I was able to figure it out. I missed the "jumper cable" between NC and I03. If you ordered a kit it does not come with this. Luckily I had some spare female jumper wires so I used one to connect the NC and I03 pins and it fixed the issue. I highly recommend reading this post if you have not ...

Hello, I just finally completed my build of my Rostock Max V2. I decided to upgrade right away to the Duet. I also bought an FSR kit from Ultibots and that all installed. I am having issues with the auto calibration though. Whenever I do the auto calibration it always does it in the air maybe... 4mm ...