Search found 2 matches
- Mon May 16, 2016 7:32 pm
- Forum: ERIS Delta
- Topic: ERIS Early adopter feedback
- Replies: 403
- Views: 364797
Re: ERIS Early adopter feedback
More on Machine #6. Auto Calibrate leaves a very tight fit, perhaps contact at front side and a normal gap at the back side. Manual height setting possible? Or possibly use six points to auto set height, vs. three points. Observation: Is the too-tight gap preventing extruder from discharging molten ...
- Mon May 16, 2016 7:10 pm
- Forum: ERIS Delta
- Topic: ERIS Early adopter feedback
- Replies: 403
- Views: 364797
Re: ERIS Early adopter feedback
Machine #6. Frustrating compared to building & calibrating the Max V2. Still unable to get a print started. Seated tube in hot end, it was not in position. Drive gear on cold end was out of place and spitting the filament out the side, re-positioned. Auto Feed script just spins and shreds the ...