Welcome to the SeeMeCNC Community

I'm not using the duet board, I have A v2 with the Rambo board.

This is so cool. You motivated me to solve the same behavior. I think if your slicer supports an ending script to turn off the hotend and bed, an M107 command should automatically turn the fan off as part of the process. Man... I've been bugged by that but never motivated enough to fix it. But ...

I just installed the berd air max v2 kit on my rosrock v2 last weekend. Gotta say love the cooling though a little louder than I like I'm still happy. I ran into an issue though and hoping I can get some help... After my prints finish the cooling kit continues to run and won't turn off unless I ...

I've been tinkering around and found thst my nozzle diameter was set to 0.5mm the default setting. Since I had installed an e3d v6 hot end while I built my rostock I didn't think of changing this... probably missed it in the instructions... Anyway after adjusting it I found that the stringing and ...

Ok I guess the picture attachment tool isn't working. here are three pictures showing whats happening. [img]http://i.imgur.com/4RefUCr.jpg[/img] - Top layer bad layers as it tapers down [img]http://i.imgur.com/yoW0rIt.jpg[/img] - First layer (bottom) not sure what happen as the other 4 pieces that ...

I'm having some issues with my layers. I'm not sure what's causing this as most of the part will print just fine and then Ill get these areas were it seems like the filament just didn't melt.. It's odd as this doesn't happen consistantly either, I can have some taller prints come out just fine and ...