Welcome to the SeeMeCNC Community

The script I've done doesn't "pause" but... There is a 'sleep' for 3 seconds (gcode M1 S3) at the three corners/posts/columns and in the middle. Perhaps Repetier can jog at this point, but the time frame is too short? I want to dig into this more and get something that works for the radius too.

I have one of these I am about to modify for use. The spring the forces the plunger down was easily removed. There are 3 screws on the far side of the photo that hold the blue part on. Gently lever the blue part up, and remove the internal spring. I just have to cut the 'C' part and make a mount for ...

The printer I'm using this in a is a Rosock Kit from SMCNC, with the Onyx bed and borosilicate glass. So it should be pretty flat. I did see it lifting up of the bed a little when making the moves from centre to upright - found the "Delta arm blues" posts... Took the delta arms off and used fingers ...

Yes - got it uploaded last night but had problems getting into Youtube on the desktop (Mobile phone - poorly focused but the gist is there)

[youtube]http://www.youtube.com/watch?v=1Q00_aYUWqw[/youtube]

Here is a script I use to assist in adjusting the Z-MAX endsop screws - use with caution! It automates the dropping of the extruder to the centre of the heated bed, and then out to each upright - placing the corresponding delta arms almost vertical. You can then eyeball (at first) the adjustments ...

I had a similar problem on a known good unit (Built one week prior @ MRRF with SeeMeCNC present) The harness uses standard IDC connector ribbon cables and the PCB http://shop.seemecnc.com/LCD-to-RAMBo-adapter-PCB-kit-LCD2RAMBO.htm OS: Fedora 17 Rambo firmware pulled off github, https://github.com ...

Spend a very hard working weekend at the Mid West Rep-Rap Festival building the Rostock MAX. It took about 30 hours to solo build as well as helping others where I could. Big thanks to all that were involved in putting on that event! Got 4 test prints done without getting into serious calibration ...